FAQ's

How to select the ring diameter?

Most of our clients use a ring with a 45-mm diameter. However, other diameters are available. The following is a 4-step procedure to help you determine the right diameter for you.

 

Lenght in mm lenght in inches Ring size

110 mm à 118 mm

4.33 à 4.67 inches

Ø 36

119 mm à 132 mm

4.68 à 5.2 inches

Ø 40

133 mm à 148 mm

5.21 à 5.82 inches

Ø 45

149 mm à 163 mm

5.83 à 6.41 inches

Ø 50

Characteristics of the resin

What is biosourced resin and why use it for a male chastity device?

Our chastity devices are made of biosourced resin from sustainable resources (plants), in replacement of chemical and petroleum products.

This resin combines properties that have never before been brought together, for example, transparency and resistance to impacts, as well as a slower rate of development of bacteria.

  • The resin is very resistant to chemical agents. It contains no solvents, no petroleum-based products and no cadmium or heavy metals
  • The resin is not classified as toxic
  • The resin demonstrates antibacterial qualities slowing the growth of bacteria into direct contact with the skin, mucus membranes or tissue. The resin is odorless and induces no allergic reaction
  • The resin contains no bisphenol, latex, phtalates, etc.
  • The resin is very resistant to pressure and has good mechanical qualities
  • It is very resistant to chemical agents, solvents, oils and water
  • The resin is resistant to UV rays
  • Even though the resin comes from natural products, it doesn’t wear away or decompose over time

Recommendations for use and care

You may use any type of lubricant… water-based, silicone, those composed of plant or animal oils. The chastity device may be left in the sun, however, it will tend to turn slightly yellow if you expose it over a long period.

The chastity device changes its structure when exposed to temperature changes. At a temperature of 20°C (68°F), the device will be hard like plastic. At 36°C (97°F), it will become slightly silken, which will provide extraordinary comfort for the person who wears it. If you take a very hot bath without removing your device, it might become almost as soft as silicon. However, its resistance to tearing will be lessened. It is thus strongly recommended to avoid bending or compressing the device when it reaches a temperature that is higher than body temperature. The resin can endure temperatures of up to 150°C (300°F); it can therefore be put in a dish washer or be sterilized.

Placement of the chastity device

The HolyTrainer has the particularity of having a tube that is attached to the ring. Placing the penis and the scrotum in the ring is very easy. The tube is then placed in the ring, guaranteeing a firm attachment and totally enclosing the member from the bottom of the abdomen to the end of the penis. Since the tube is placed in the middle of the ring, no pinching of the skin can occur.


1) Insert the ring. Pull the skin of the scrotum until the testicles are fully inserted

2) Insert the penis into the ring

3) Lightly lubricate the tube and insert the penis and slide the tube to inside the ring

4) Lock the Magic Locker and remove the key

Insertion and use of the "MagicLocker"

he chastity device comes with a locking system « MagicLocker » that slides through the ring & tube to holds them together. The « MagicLocker » is tightly adjusted. If you find it difficult to insert, you can always use some lubricant or put the ring & tube under warm water.

It is important to verify and test the locking system before you put it on. The « MagicLocker » has to be inserted without applying too much strenght. Before turning the key it is important that the « Magic Locker » is all the way in. Then turn the key clockwise to secure th system. The key will be released only when the system is closed.

In conclusion

Biosourced resin satisfies expectations within the framework of sustainable development with alternative products and processes that are more respectful of man and his environment.